![]() Selecting the wrong technology could very easily result in you paying thousands for a system that completely misrepresents what would actually happen to your golf ball – and cause your golf performance outdoors to suffer as a result! Make sure you thoroughly research and understand the implications of selecting your launch monitor technology for use indoors. Even with the enormous minimum space of 25ft of ball flight recommended by manufacturers (plus approximately 9ft between the launch monitor and the golf ball!), the system will always struggle to accurately represent the curvature, especially from off-centre strikes. The less ball flight available, the less accurate the calculation becomes. Unfortunately this is not the case radar relies on tracking ball flight to calculate the launch conditions, and crucially the axis-tilt (side spin) of the golf ball. The misconception is that because the doppler radar can accurately track ball flight outdoors that it can perform the same task indoors. You will experience randomness in ball flight and in the distance you hit each club.Ī lack of reliability and consistency is not just present in lower-end systems it is also found in high-end radar launch monitors. the simulator enclosure) over time.Īlthough it is possible to create a golf simulator with a cheaper, lower-end measurement system, the likelihood is that the shot you see on the software will not consistently match the shot pattern you would see in the real world. Many customers decide to invest in the best possible launch monitor as a must-have, and then build the rest of the ‘aesthetic experience’ (i.e. Launch monitors have been designed solely to measure and produce the most accurate and reliable golf ball – and often golf club – data possible. The other type of measurement system used within a golf simulator is known as a launch monitor. This type of measurement system must meet certain simulator criteria and not just the requirement to measure the ball. The first is a solution that has been designed and built as part of the simulator design. ![]() The majority of measurement systems within golf simulators are one of two types. Primarily, most simulators use either camera, radar or infrared tracking technology. ![]() Golf simulators vary based on the type of measurement technology they use. It is the one thing that controls whether the experience is representative of what the golfer would see outside on the golf course. The system measuring the golf ball and providing the ball flight data is the single most important component of any simulator solution. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |